Raritan PMC-1000 - Switching on an Actuator; Switching off an Actuator

Chapter 5: Using the Command Line Interface
506
Switching On an Actuator
This command syntax turns on one actuator.
#
control actuator <n> on
To quicken the operation, you can add the parameter "/y" to the end of
the command, which confirms the operation.
#
control actuator <n> on
/y
Variables:
• <n> is an actuator's ID number.
The ID number is available in the BCM2 web interface or using the
show command in the CLI. It is an integer between 1 and 32.
If you entered the command without "/y", a message appears, prompting
you to confirm the operation. Then:
 Type y to confirm the operation, OR
 Type n to abort the operation
Switching Off an Actuator
This command syntax turns off one actuator.
#
control actuator <n> off
To quicken the operation, you can add the parameter "/y" to the end of
the command, which confirms the operation.
#
control actuator <n> off
/y
Variables:
• <n> is an actuator's ID number.
The ID number is available in the BCM2 web interface or using the
show command in the CLI. It is an integer between 1 and 32.