Raritan PMC-1000 User Manual

Chapter 5: Using the Command Line Interface
509
-- OR --
#
reset activeEnergy outlet <outlet_n> /y
If you entered the command without "/y", a message appears prompting
you to confirm the operation. Type y to confirm the reset or n to abort it.
Variables:
• <n> is the inlet number.
• <outlet_n> is an outlet number.
Resetting to Factory Defaults
The following commands restore all settings of the BCM2 device to
factory defaults.
To reset BCM2 settings after login, use either command:
#
reset factorydefaults
-- OR --
#
reset factorydefaults
/y
To reset BCM2 settings before login:
Username:
factorydefaults
See Using the CLI Command (on page 521) for details.
Network Troubleshooting
The BCM2 provides 4 diagnostic commands for troubleshooting network
problems:
nslookup , netstat , ping , and traceroute . The diagnostic
commands function as corresponding Linux commands and can get
corresponding Linux outputs.
Entering Diagnostic Mode
Diagnostic commands function in the diagnostic mode only.
To enter the diagnostic mode:
1. Enter either of the following modes:
 Administrator mode: The # prompt is displayed.
 User mode: The > prompt is displayed.
2. Type diag and press Enter. The diag# or diag> prompt appears,
indicating that you have entered the diagnostic mode.
3. Now you can type any diagnostic commands for troubleshooting.

Raritan PMC-1000 Specifications

General

Brand	Raritan
Model	PMC-1000
Category	Measuring Instruments
Language	English