Chapter 3: Using the Web Interface
2. Click to select an appropriate firmware file.
3. Click Upload. A progress bar appears to indicate the upload process.
4. Once complete, information of both installed and uploaded firmware
versions as well as compatibility and signature-checking results are
displayed.
If anything is incorrect, click Discard Upload.
5. To proceed with the update, click Update Firmware.
Warning: Do NOT power off the BCM2 during the update.
6. During the firmware update:
A progress bar appears on the web interface, indicating the
update status.
The front panel display shows the firmware upgrade message.
See Showing the Firmware Upgrade Progress.
The outlet LEDs flash if the relay boards are being updated. If the
firmware update does not include the update of the relay board
firmware, outlet LEDs do NOT flash.
No users can successfully log in to the BCM2.
Other users' operation, if any, is forced to suspend.
7. When the update is complete, the BCM2 resets, and the Login page
re-appears.
Other logged-in users are logged out when the firmware update
is complete.
Important: If you are using the BCM2 with an SNMP manager,
download its MIB again after the firmware update to ensure your
SNMP manager has the correct MIB for the latest release you are
using. See
Using SNMP
(on page 345).
Alternatives:
To use a different method to update the firmware, refer to:
•
Firmware Update via SCP
(on page 514)
• Bulk Configuration or Firmware Upgrade via DHCP/TFTP
• Firmware Upgrade via USB
To Next Page
Loading...
