4 | Transport
80.06.083_iCombiPro-iCombiClassic_IM_en-US 25 / 100
n
Make sure that the lifting aid, installation surface and protective clothing
are clean and grease-free.
n
Only lift the unit by hand using the bars of the lifting aid. Do not use any
mechanical aids for lifting.
CAUTION
Sharp edges on the panels
Risk of cuts on the panels when working on the unit.
n
Wear protective gloves.
n
Only transport the unit at the approved transport points.
CAUTION
Risk of crushing and injury during Combi-Duo installation
There is an increased risk of crushing hands and fingers in Combi-Duo
installations.
The distance between the bars of the lifting aid and the Combi-Duo kit is
very small when positioning on the kit.
n
Make sure that the unit is placed carefully on the kit and is stable on the
installation surface.
n
Place the unit on the installation surface so that there is sufficient space
between the kit and the lifting aid to protect hands and fingers.
NOTE
Correctly attached lifting aid wobbles without load
If the lifting aid is fully and correctly attached, a slight movement in
horizontal direction can be detected without load.
The screw connection prevents the lifting aid from slipping out of the lifting
points. Transport can be carried out safely.
Observe the instructions in the installation manual.
a All side panels are closed.
a The unit is as close as possible to the final installation surface.
a A torque wrench with a suitable attachment is ready for use.
a The installation surface, the unit and the lifting aid are clean and free of
grease.
a Wear appropriate protective clothing, e.g.work gloves.
To Next Page
Loading...
Need help?
General
