Rauch AXIS H EMC Series - Wear Parts and Screw Connections

AXIS-H EMC/AXIS-H EMC+W
Retrofitting the LS relief at the block
RAUCH Landmaschinenfabrik GmbH D-76547 Sinzheim
Customer service hotline: +49 (0)7221 985 250
E-mail: service@rauch.de
Page 1
of 1
04.11.2014
Chapter 520
AXIS H-EMC in LS operation => Speed variations of the spreading discs
 For some tractors, a missing and/or insufficient LS relief in the tractor’s hydraulic system
may lead to speed variations of the spreading discs.
 Solution: For hydraulic blocks delivered as of calendar week 48/2011, a relief can be
created in the hydraulics block by means of screw-in blinds. The new blocks can be visibly
identified by means of the additional closure screw (labelling).
 Upon the release of the closure screw, the M6 sealing plug can be replaced by a blind.
 Start with a 0.3 mm blind.
If the improvement is insufficient, test the further sizes 0.5 / 0.6 / 0.7.
 The blinds are available as spare parts set under order no. 2057677.