AXIS-H EMC
Flow factor (FF) increase on both sides
RAUCH Landmaschinenfabrik GmbH D-76547 Sinzheim
Customer service hotline: +49 (0)7221 985 250
E-mail: service@rauch.de
Page
1
of
1
29.10.2014
Chapter 730
• The flow factor increases immediately on both sides when spreading begins
• Error message: Flow factor outside acceptable limits
Fertiliser flow factor outside of the
controllable range (compare
fertiliser chart)
Switch to manual mode
Return pressure sensor defective
Pressure sensor return check in the
Test/Diagnosis menu
=> see chapter 5
Metering slide actuators sluggish or
defective
Metering slide actuator check in the
Test/Diagnosis menu
=> see chapter 5
To Next Page
Loading...
