AXIS-H EMC
Flow factor (FF) decrease on both sides
RAUCH Landmaschinenfabrik GmbH D-76547 Sinzheim
Customer service hotline: +49 (0)7221 985 250
E-mail: service@rauch.de
Page
1
of
1
29.10.2014
Chapter 740
• The flow factor decreases immediately on both sides when spreading begins
• Error message: Flow factor outside acceptable limits
Fertiliser flow factor outside of the
controllable range (compare fertiliser
chart)
Switch to manual mode
Return pressure sensor defective
Pressure sensor return check in the
Test/Diagnosis menu
=> see chapter 5
Metering slide actuators sluggish or
defective
Metering slide actuator check in the
Test/Diagnosis menu
=> see chapter 5
Clogging in the outlet, e.g. due to
fertiliser remaining in the hopper for a
prolonged period
Low, moist fertiliser quality
Empty the hopper and correct the
clogging
CAUTION! Disconnect the machine
plug at the outlet to stop the agitator
prior to any cleaning attempts!
To Next Page
Loading...
