AXIS-H EMC
Field-Handle joystick
RAUCH Landmaschinenfabrik GmbH D-76547 Sinzheim
Customer service hotline: +49 (0)7221 985 250
E-mail: service@rauch.de
Page
1
of
2
27.10.2014
Chapter 490
AXIS-H EMC joystick assignment as of SW 3.00.00
As of software version 3.00.00, the AXIS-H EMC can also be operated by joystick
The joystick must comply with ISOBUS Auxiliary Level 4.1 = AUX N/ AUX 2
Default assignment for WTK Field-Handle (As of software version 6.11)
Rauch no. 2057592:
This assignment is automatically loaded as default if this joystick type is connected:
Other joystick types:
The assignment of the keys must be defined
=> refer to the operating manual of the
terminal manufacturer
- Müller Joystick III (corresponds to WTK Field-Handle, however, cannot be loaded
with default assignment)
- Tractor-specific joystick, e.g. Fendt… => Observe the software version!
After definition of the keys, the assignment can be saved in the AXIS implement ECU.
At the next start, the functions are automatically assigned to the keys:
Service code 3354
To Next Page
Loading...
