AXIS-H EMC/AXIS-H EMC+W
Service menu >SW 2.05.00
RAUCH Landmaschinenfabrik GmbH D-76547 Sinzheim
Customer service hotline: +49 (0)7221 985 250
E-mail: service@rauch.de
Page
1
of
2
27.10.2014
Chapter 460
(Figures refer to AXIS-H 30.1 EMC with CCI terminal)
See chapter “Machine options”
When the spreader leaves the factory, all
calibration values are stored in the boot
menu.
In the event of calibration problems, the
factory settings can be re-loaded there
Please refer to the chapter Calibrate slider
Please refer to the chapter Calibration of
drop point
Please refer to the chapter Calibration of
weigh cells
Please refer to the chapter LIN settings
To Next Page
Loading...
