Rauch AXIS H EMC Series - Checking the Drop Point

AXIS-H EMC/AXIS-H EMC+W
Check: LIN actuators
RAUCH Landmaschinenfabrik GmbH D-76547 Sinzheim
Customer service hotline: +49 (0)7221 985 250
E-mail: service@rauch.de
Page 1
of 1
29.10.2014
Chapter 650
LIN actuators are controlled via a LIN BUS system. The actuators feature integrated software and
exchange information with the implement ECU via a bus connection.
The following functions are controlled via LIN actuators:
- Drop point
- Hopper cover
- AXMAT
- TELIMAT (AXIS-M 50.1W only)
(Figures refer to AXIS-H 30.1 EMC with CCI terminal)
With Start self test the system checks the
(activated) LIN BUS devices
DP actuator versions 1.1.0 = Index b
DP actuator versions 1.0.0 = old version
Hopper cover = not connected
Note: After replacement of the implement ECU, of
the actuators or a software update, the LIN actuators
have to be reinitialised => see chapter 3
Error codes:
0 = OK
2 = blockage
4 = overload