AXIS-H EMC
Alarm messages
RAUCH Landmaschinenfabrik GmbH D-76547 Sinzheim
Customer service hotline: +49 (0)7221 985 250
E-mail: service@rauch.de
Page
1
of
3
29.10.2014
Chapter 710
Alarm messages:
Information for the driver concerning the operating condition
Information on faults
Confirmation prompt
No. Message in display Meaning and possible cause
1 Fault in metering system.
The actuator for the metering system
cannot reach the set value it is to be
moved to.
Blockade
No position message
2 Speed or application rate to
high.
Metering slide alarm
The maximum metering
opening is
reached.
The set application rate (+/- appl.
rate)
exceeds the maximum
3 Flow factor lies outside
acceptable limits.
The flow factor must lie within a range
between 0.40 and 1.90
The newly calculated or entered
flow
factor is outside this range
4 Left hopper empty. The level sensor on the left reports
„empty“.
The left-hand hopper is empty.
5 Right hopper empty. The level sensor on the right reports
„empty“.
The right-hand hopper is empty.
16
Move to drop point.
Yes = START
Safety request before drop point is
approached automatically.
Drop point can be set in the menu
Fast emptying
17 Error in drop point setting.
The actuator for the drop point setting
cannot reach the set value it is to be
moved to.
Blockade
No position message
Calibration test
To Next Page
Loading...
