Rauch AXIS H EMC Series - Page 125

AXIS-H EMC
Workshop manual
RAUCH Landmaschinenfabrik GmbH D-76547 Sinzheim
Customer service hotline: +49 (0)7221 985 250
E-mail: service@rauch.de
Page 2
of 2
29.10.2014
Chapter 7
Chapter 7 “Troubleshooting, advanced settings”
710 Alarm message overview
720 Idle measurement abortion, idle measurement is not fully completed
721 As of SW 3.00.00: Idle measurement is not completed
730 Flow factor increase on both sides
740 Flow factor decrease on both sides
750 Flow factor increase or decrease on one side
760 No flow factor control
770 Disc speed fluctuation
780 Actuator buzzing or pulsation
790 No drop point actuator function