Rauch AXIS H EMC Series - Safety Equipment on the Machine

AXIS-H EMC
Checking and setting the metering slide
basic settings
RAUCH Landmaschinenfabrik GmbH D-76547 Sinzheim
Customer service hotline: +49 (0)7221 985 250
E-mail: service@rauch.de
Page 1
of 2
27.10.2014
Chapter 310
The mechanical basic settings of the metering slides are usually configured in the factory.
The settings should be checked or corrected under the following circumstances:
- Installation of a new metering slide
- Uneven application rate on the left/right-hand side
- Highly unbalanced flow factor on the left and right-hand side
Auxiliary equipment:
- Lower link pins category II (28mm)
1. Basic settings check
Remove the spreading discs.
Remove the retention bolt of the actuators.
The metering slide can now be moved
manually. Open the slide completely.
Place the 28 mm lower link pin from the
bottom or top vertically into the opening and
slowly close the metering slide up to the
bolt.
 The bolt has to be positioned in the
centre gap as illustrated.
If the setting is correct, a scale position of
85 must be displayed.