Rauch AXIS H EMC Series - 770_Wurfscheibendrehzahl_unruhig_EN(UK)

AXIS-H EMC
Disc speed fluctuation
RAUCH Landmaschinenfabrik GmbH D-76547 Sinzheim
Customer service hotline: +49 (0)7221 985 250
E-mail: service@rauch.de
Page 1
of 1
29.10.2014
Chapter 770
 Sufficient oil in the tractor
 Tractor motor speed at least 1400 1/min
 Constant current: Tractor control unit configuration
 Load Sensing: Sufficient cross-section of pressure, return and LS lines
 Coupling plug of the LS line correctly connected
+ Spreading disc speed fluctuating when
idling
+ Proportional valve venting => see
chapter 4
1
+ The spreading disc speed falls or
starts to fluctuate if the fertiliser comes
into contact with the spreading disc
+ Sufficient tractor power supply (voltage
drop if the electric agitator is activated)
+ Sluggish agitator drive
+ Corroded machine cable harness
2
+ The spreading disc speed falls or
starts to fluctuate if the fertiliser comes
into contact with the spreading disc
+ LS system: LS signal of the spreader
too high/Tractor reacts very sensitively to
the LS signal => Install LS blind => see
chapter 4
4
+ The spreading disc speed falls or
starts to fluctuate if the fertiliser comes
into contact with the spreading disc
Subject to technical consultation by
Rauch
+ By changing the parameters, the
controller behaviour for spreading disc
control can be influenced
3
+ The spreading disc speed falls or
starts to fluctuate if the fertiliser comes
into contact with the spreading disc
+ Highly uneven terrain (fertiliser
bounces on the spreading disc)