Internal service information
AXIS-H EMC+W SW>3.00.00
RAUCH Landmaschinenfabrik GmbH D-76547 Sinzheim
Customer service hotline: +49 (0)7221 985 250
E-mail: service@rauch.de
Page
1
of
3
27.10.2014
Chapter 481
As of software > 3.00.00
Control parameters: Settings and explanations
•
With the control parameters, the spreader function can be set. For this
reason, any modifications to these parameters are subject to consultation
with the technical customer service and should only be implemented by
specialist staff.
•
The parameters are to be checked after each update.
The factory parameter settings are displayed!
(Figures refer to AXIS-H 30.1 EMC with CCI terminal)
Enter code 3354
To Next Page
Loading...
