Rauch AXIS H EMC Series - Page 91

Internal service information
AXIS-H EMC+W
RAUCH Landmaschinenfabrik GmbH D-76547 Sinzheim
Customer service hotline: +49 (0)7221 985 250
E-mail: service@rauch.de
Page 3
of 3
27.10.2014
Chapter 480
Press buf size
=> Buffer for sampling rate
(number of measuring values for the FF calculation)
Idle buf size => see above at idle measurement
Flow factor step => maximum admissible step
of the FF
Fill tolerance => currently not relevant
Max valid => currently not relevant
+/- LBS Limit => admissible tolerance for AD
values
Overload limit (V)
=> max. signal voltage of the
overload protection unit
Deactivation time (sec) => deactivation delay
of the agitator in case of overload
Actuator Min PWM => minimum actuator
speed
Disc Max PWM => limits the maximum speed of
spreading discs
Disc Min PWM => lower speed limit of
spreading discs
Idle Limit1 (%)
=> currently not relevant
Idle Limit2 (%) => currently not relevant
Disc PWM freq. => PWM for the activation of
proportional valves
SC CRP_XI => calculation of the fertiliser hitting
point from the coupling point
Velocity filter => forward speed filter. For GPS
signal or very unsteady speeds, the value can be
increased (max. 12)