Rauch AXIS H EMC Series - 020_Inhaltsverzeichnis_EN(UK)

Tableofcontents-AXISH-EMC
WorkshopManual
Chapter 1 Introduction
110 Preface
120 Using the manual
Chapter 2 Basic information
210 Layout and components
220 Spreader basic information
230 EMC technology basic information
Chapter 3 Mechanical system
1. Metering slide basic settings
2. Drop point (DP) basic settings (currently not available)
3. Weigh cell and weigh frame assembly (currently not available)
Chapter 4 Electronic system
400 Implement ECU software update
401 Update tool installation
410 AXIS-H EMC SW 2.08.00 update
411 AXIS-H EMC update as of SW 3.00.00
420 Metering slide calibration
430 Drop point actuator initialisation
440 Drop point actuator calibration
450 Weigh cell calibration
460 Service menu overview and description
470 Service menu machine options overview and description
471 Service menu machine options overview and description as of SW 3.00.00
480 Control parameters and their function
481 Control parameters and their function as of SW 3.00.00
490 Joystick information as of SW 3.00.00