AXIS H-EMC/ AXIS H-EMC + W
Implement ECU software update as of
SW 3.00.00
Rauch Landmaschinenfabrik GmbH
+49 (0)7221/985-250 service@rauch.de
Page
1
of
16
Update SW
3.00.00
27/08/14
Chapter 411
1. Requirements:
• PEX-Loader and LH-Loader are installed on the PC
Update tool installation instructions
2. Required accessories:
PC with USB port: Update cable R2058068
If the cable is connected to the PC for the first time, a driver
is automatically installed. For this, an internet connection
may be required.
PC or laptop with serial interface: Update cable R2057068
The update cable is connected to the AXIS cable harness. The plug has the
designation PG and is normally suspended on the left-hand side behind the attachment
frame. Remove the blind cap.
! Do not connect the update cable yet!
To Next Page
Loading...
