Rauch AXIS H EMC Series - Spreading at the Headland

Internal service information
AXIS-H EMC+W
RAUCH Landmaschinenfabrik GmbH D-76547 Sinzheim
Customer service hotline: +49 (0)7221 985 250
E-mail: service@rauch.de
Page 2
of 3
27.10.2014
Chapter 480
Service menu, page 2
Efficiency R and L
=> efficiency of the oil
motors determined at the factory
EMC factor => see following column
Actuator P
Actuator I Control parameter for
Actuator D metering slide actuators
EMC factor
=> EMC factors for the individual
spreading discs
PWM limit value
=> minimum control rate for
proportional valve
Hydraulics P
Hydraulics I Control parameter for
Hydraulics D proportional valve
Press tolerance (%) => admissible speed
variance during which EMC control is implemented
Idle tolerance => see above at idle
measurement
PWM limit value
=> minimum control rate for
proportional valve
Hydraulics P
Hydraulics I Control parameter for
Hydraulics D proportional valve
Press tolerance (%) => admissible speed
variance during which EMC control is implemented
Idle tolerance => see above at idle
measurement
AXIS
-
H 30.1
AXIS
-
H 50.1