AXIS-H EMC
Remove the gear unit
RAUCH Landmaschinenfabrik GmbH D-76547 Sinzheim
Customer service hotline: +49 (0)7221 985 250
E-mail: service@rauch.de
Page
4
of
4
04.11.2014
Chapter 540
3. Determine and/or enter the efficiency of the gear unit
After final assembly of the spreader in the factory, the efficiency of the gear
unit is checked in a test bay and entered in the software.
After repair or replacement of the gear unit, this value may need to be
checked or corrected. Indications include:
i. Uneven emptying of the spreader
ii. Incorrect application rate
Prior to work, check the spreading discs and spreading vanes for wear and for fertiliser
deposits. Otherwise, the results may be incorrect.
+ Compare the quantity spread according to
the trip counter with the quantity displayed by
the scales
+ Check whether the spreader is discharged
unevenly (! No boundary spreading and no
section control activated!)
FF too low => Increase efficiency
FF too high => Reduce efficiency
Application rate too high => Increase
efficiency
Application rate too low => Decrease
efficiency
Balanced discharge => Adjust the efficiency
on both sides
Unbalanced discharge => Check whether too
much or too little fertiliser is applied and
adjust the efficiency accordingly on one side
Note: If the efficiencies determined in the factory are lost after an update, these can
be obtained from the Rauch technical customer service. For this purpose, the
serial number of the spreader is required.
To Next Page
Loading...
