AXIS H-EMC/ AXIS H-EMC + W
Implement ECU software update as of
SW 2.08.00
Rauch Landmaschinenfabrik GmbH
+49 (0)7221/985-250 service@rauch.de
Page
2
of
16
Update SW
2.08.00
27/08/14
Chapter 410
3. Preparation
•
Implement ECU connected to ISO terminal, power supply established
Note down the settings and calibration data (example settings)
(
= particularly important
calibration and settings data)
Fertiliser settings
Machine configuration
Under fertilizer chart, the
complete spreading tables for
the different fertilisers can be
found.
As of SW 2.05.00, the spreading
tables are maintained, however,
they must be checked after the
update.
To Next Page
Loading...
