AXIS H-EMC/ AXIS H-EMC + W
Implement ECU software update as of
SW 3.00.00
Rauch Landmaschinenfabrik GmbH
+49 (0)7221/985-250 service@rauch.de
Page
16
of
16
Update SW
3.00.00
27/08/14
Chapter 411
Machine settings:
Check and restore the settings in the
machine settings menu
Old software only < 2.03.00: Initialisation of the drop point actuators
If software <2.04.10 was installed before the
update, the drop point actuators must be
reinitialised
Chapter 3.30 Drop point initialisation
Last but not least
:
After checking the settings, the calibration of the actuators for metering slides and drop point
as well as the calibration of the weigh cell (AXIS H 30.1EMC+W and AXIS H 50.1 EMC+W
only) must be checked.
Please refer to chapter 5 “Test/Diagnosis”
To Next Page
Loading...
