Rauch AXIS H EMC Series - Settings as per Fertiliser Chart

AXIS-H EMC/AXIS-H EMC+W
Metering slide actuator calibration
RAUCH Landmaschinenfabrik GmbH D-76547 Sinzheim
Customer service hotline: +49 (0)7221 985 250
E-mail: service@rauch.de
Page 2
of 5
27.10.2014
Chapter 420
The menu defines the positions to be
initiated
Move the actuator for the right-hand
metering slide using the buttons until the
scale indicates a position of 0.
Then confirm with OK.
! Ensure that the actuator is not at the end
stop. Otherwise, the carrier plate may be
shifted into the long holes. If the actuator
can be moved under position 0 as shown in
the figure, the settings are correct.
Now, move the actuator until the scale
position 580. Then confirm with OK.
! Ensure that the actuator is not at the end
stop. Otherwise, the setting must be
corrected. If the actuator can be moved
above position 580 as shown in the figure,
the settings are correct.