AXIS-H EMC/AXIS-H EMC+W
Metering slide actuator calibration
RAUCH Landmaschinenfabrik GmbH D-76547 Sinzheim
Customer service hotline: +49 (0)7221 985 250
E-mail: service@rauch.de
Page
5
of
5
27.10.2014
Chapter 420
2. Checking the calibration
(Figures refer to AXIS-H 30.1 EMC with CCI terminal)
By means of the
button, the
metering slide settings are activated and
the pre-defined test points can be initiated
and checked.
Repeat the calibration if the test points are
not reached.
To Next Page
Loading...
