Rauch AXIS H EMC Series - Page 73

Service information
AXIS-H EMC+W
RAUCH Landmaschinenfabrik GmbH D-76547 Sinzheim
Customer service hotline: +49 (0)7221 985 250
E-mail: service@rauch.de
Page 2
of 4
27.10.2014
Chapter 440
The menu defines the positions to be
initiated
Move the actuator for the right-hand drop
point using the buttons until the scale
indicates a position of 0.
Then confirm with OK.
! Ensure that the actuator is not at the end
stop. Otherwise, the setting of the
mechanical levers is to be corrected. If the
actuator can be moved under position 0 as
shown in the figure, the settings are correct.
Now, move the actuator until the scale
position 9.5. Then confirm with OK.
! Ensure that the actuator is not at the end
stop. Otherwise, the setting of the
mechanical levers is to be corrected. If the
actuator can be moved above position 9.5
as shown in the figure, the settings are
correct.
Repeat this process for the
left
-
hand
side.