Rauch AXIS H EMC Series - Page 98

AXIS-H EMC
Workshop manual
RAUCH Landmaschinenfabrik GmbH D-76547 Sinzheim
Customer service hotline: +49 (0)7221 985 250
E-mail: service@rauch.de
Page 2
of 2
04.11.2014
Chapter 5
Chapter 5 “Hydraulic drive”
510 Hydraulic block layout
511 Component drawing: Hydraulic block layout
520 LS relief at the hydraulic block
530 Proportional valve venting
540 Oil motor drive unit disassembly
550 Gearbox oil change
560 Pressure sensors
561 Pressure sensor 40 bar - old version
562 Pressure sensor 40 bar- new version
563 Pressure sensor 250 bar