Raven Phoenix 300 - Receiver Display Menu

3
Manual No. 016-0171-548 Rev. C 13
Display Menus
OmniSTAR
®
XP/HP Restart
If the OmniSTAR XP or HP service is set as the differential source, press the key from the Home screen
to access the XP/HP Auto-Restart screen.
This screen displays the XP/HP restart status. When using the OmniSTAR XP or HP correction source, restart
status is the last position, or “seed,” where the receiver received an OmniSTAR correction and may be stored
for subsequent receiver start ups to reduce the time required for the receiver to converge or lock onto
OmniSTAR correction.
• No seed is available if the screen displays “NOT AVAILABLE.”
• If a seed is available for storage, “NOT STORED” will be displayed on this screen. Press the arrow
key to change the state to “DO RESTORE.” The receiver will store the last seed position for use on the next
startup.
• If a seed is available upon startup, this screen will display “RESTORING.”
Receiver Display Menu
Access the Receiver display menu to view the receiver model, Raven serial number, and firmware version.
Receiver Information
From the Home screen, press the key to view the receiver information.
This screen displays the receiver serial number and the receiver software version number.
Receiver
Software
Version
Receiver
Serial
Number