Raven Phoenix 300 - Pre-Defined Setting Configurations; Radar Configurations

Chapter 3
24 Phoenix 300 Installation & Operation Manual
Pre-Defined Setting Configurations
The following presets are available and may be helpful to quickly configure the Phoenix 300 GPS receiver. The
settings may be adjusted after the preset is applied to customize the GPS receiver for the equipment or
application needs.See the following chart for each of the specific configuration setting values.
TABLE 3. Phoenix 300 Receiver Preset Configurations
Radar Configurations
Press the key again and press either the or key to access the Radar Configuration menu.
Note: Refer to the Simulated Radar Speed Configuration Screens section on page 26 for additional
information regarding the Radar Configuration Screen.
Configuration Setting
Presets
Do Not Change Zero All Raven SmarTrax Raven Classic
Port A Baud Rate
Current Setting 38400 19200 19200
Port A Messages
Current Settings None
GGA - 0.1 (10 Hz)
VTG - 0.1 (10 Hz)
ZDA - 10 (0.1 Hz)
GGA - 0.1 (10 Hz)
VTG - 0.1 (10 Hz)
Port B Baud Rate
Current Setting 38400 19200 4800
Port B Messages
a
a. If the receiver is configured for RTK corrections, the port B output is automatically disabled. For other correction
sources, the port B output messages will be set as described.
Current Settings None
GGA - 0.2 (5 Hz)
VTG - 0.2 (5 Hz)
ZDA - 1 (1 Hz)
GGA - 1 (1 Hz)
RMC - 1 (1 Hz)
VTG - 1 (1 Hz)
Optimization
Current Setting None No Change Pass-to-Pass
HP Seed Mode
Current Setting Manual No Change No Change
Radar Min Speed
Current Setting 0 0 0
Radar Clamp Speed
Current Setting 0 0 0
Radar Hold Time
Current Setting 0 0 0
Differential
Current Setting None No Change WAAS