Chapter 4
42 Phoenix 300 Installation & Operation Manual
Port A Settings
Baud Rate
Press the key and the output baud rate for Port A
is displayed.
Press the key and use the or keys to
select the output message rate for Port A on the
Phoenix 300 receiver.
Press the key to save the new setting.
Message Outputs
Press the key to access the Port A Message
Output screen.
To view the output rate for each NMEA message,
press either the or key and use the or
keys to scroll through the available message
types. Refer to the National Marine Electronics
Association (NMEA) Messages section on page 44 for
a description of the available message types.
Note: The current output rate for each message is displayed in seconds. An interval of 0.0 sec disables
output of the selected messages on Port A.
To change a output rate for a message, press the key and use the or keys to set the first digit.
Press the key to advance to the next digit or press the key to save the displayed output setting.
The table below lists the optional interval rates:
TABLE 4. Standard Output Message Rates
Press the key to return to the Port A Message Output screen.
Programmed Interval
of NMEA message
Output frequency (number of
updates per second)
0.0 OFF
0.1 sec 10 Hz
0.2 sec 5 Hz
0.5 sec 2 Hz
1.0 sec 1 Hz
To Next Page
Loading...
