Chapter 4
38 Phoenix 300 Installation & Operation Manual
OmniSTAR Auto-Restart
Press the key to display the Auto-Restart screen.
This screen displays the current mode for the OmniSTAR “seed” state. Review the OmniSTAR® XP/HP
Restart section on page 13 for more information on the seed state and using seed positions.
Press the key and use the or arrow keys to toggle the AutoRestart Mode between “Automatic”
and “Manual” on the screen.
Press the key to select the displayed setting.
Select one of the following modes for the OmniSTAR auto-restart feature:
• Automatic - Automatically stores the last position at which a differential position signal was received before
powering down the receiver. This option works well if the receiver will be powered back on at or near the
location where it was powered down.
• Manual - The operator must manually store the restart location. Use the manual mode if the vehicle will be
stored in a garage or shop where GPS signal may be weak or blocked.
Note: If the receiver is restarted further from the stored location, the receiver may need to re-converge.
Depending upon the time since the last power up and distance from the stored location,
re-convergence may take several minutes.
To Next Page
Loading...
