Raven Phoenix 300 - Utility Options Menu; Unit Preset Configuration Settings

3
Manual No. 016-0171-548 Rev. C 23
Display Menus
Utility Options Menu
Access the Utility Options to configure the Phoenix 300 to operate with other devices such as a Raven Radar
speed sensor or Raven SmarTrax automated steering system.
Unit Preset Configuration Settings
Press the key to access the Configure Unit screen.
Press the key and use the or keys to cycle through the available presets. Select one of the
available presets to set up the Phoenix 300 communication settings as shown in the Pre-Defined Setting
Configurations section on page 24.
Press the key again to select the currently displayed preset. The Phoenix 300 will automatically configure
the port baud rates and message output settings. Once the preset is applied, the display will return to Do Not
Change.
Note: Select Do Not Change to cancel any changes to the baud or messages rate settings.