Raven Phoenix 300 - Port B Settings

4
Manual No. 016-0171-548 Rev. C 43
Configuration Menus
Port B Settings
Baud Rate
Press the key to access the Port B baud rate
screen.
Note: If the Correction Mode is set to RTK, the
Port B baud rate and message output
screens will not be displayed in the
Output Configuration menu and output
from Port B will be disabled.
Press the key and use the or keys to
select the output message rate for Port B on the
Phoenix 300 receiver.
Press the key to save the new setting.
Message Outputs
Press the key to access the Port B Message
Output screen.
To view the output rate for each NMEA message,
press either the or key and use the
or keys to scroll through the available message
types.
Note: The current output rate for each
message is displayed in seconds. An
interval of 0.0 sec disables output of the
selected messages on Port B.
To change a output rate for a message, press the key and use the or keys to set the first digit.
Press the key to advance to the next digit or press the key to save the displayed output setting.