Chapter 4
30 Phoenix 300 Installation & Operation Manual
GS - Satellite Configuration Menu
The GS Configuration menu will provide the following settings when configured for satellite based GS services.
Contact a local Raven dealer for additional information or to activate a GS subscription.
Note: The GS configuration menu is only available if “GS” is selected on the Correction Mode screen.
Refer to the Correction Configuration Menu section on page 27 for more information on selecting
the correction source.
Press the key until the GS configuration screen is displayed.
Accuracy Warning
Press the key to display the accuracy warning screen.
The accuracy warning value sets the allowable horizontal accuracy (or standard deviation) for field operation.
Once the receiver determines the position solution meets the set value, the solution will be considered
converged and the appropriate status will be displayed on the Home screen.
Note: Higher values will allow the receiver to converge faster, but will allow more horizontal position
error. Smaller values will provide a more accurate position, but will take longer to converge and are
more likely to lose a converged status during field operations.
Press the key and use the or arrow keys to modify the accuracy warning value.
Press the key again to save the displayed setting.
To Next Page
Loading...
