Chapter 3
18 Phoenix 300 Installation & Operation Manual
OmniSTAR
®
Display Menu
Note: The OmniSTAR display menu may only be available if “OmniSTAR HP/XP” is selected on the
Correction Mode screen. Refer to the Correction Configuration Menu section on page 27 for more
information on selecting the correction source.
Phoenix 300 with USB receivers with the following part numbers are compatible with the
OmniSTAR correction service using GPS engine firmware version 6.40 or lower:
• 063-0173-502,
• 063-0173-559, and
• 063-0173-560.
See the Receiver Display Menu section on page 13 section for assistance with verifying the
firmware version installed on the receiver. Contact a local Raven dealer for information on
correction services available for Phoenix 300 receivers with newer firmware versions or additional
assistance.
Access the OmniSTAR display menu to view subscription status and expiration information or service
communication information right on the Phoenix 300 display. For OmniSTAR configuration options and
features, refer to the OmniSTAR® Configuration Menu section on page 35.
Note: Press the key until the OmniSTAR screen is displayed.
This screen displays the region for currently selected on the receiver. To provide the best possible correction
signal to the receiver, make sure that this setting is properly configured via the OmniSTAR® Configuration
Menu section on page 35.
To Next Page
Loading...
