4
Manual No. 016-0171-548 Rev. C 39
Configuration Menus
RTK Configuration Menu
Note: The RTK configuration menu may only be available if “RTK” is selected on the Correction Mode
screen. Refer to the Correction Configuration Menu section on page 27 for more information on
selecting the correction source.
Review the Phoenix 300 Quick Start and RTK Update Guide for more information about
requirements and unlocking RTK for the receiver. For purchasing information and assistance,
contact a local Raven dealer.
If RTK is selected as the differential correction mode, the RTK configuration screen will be available.
Press the key until the RTK Configuration screen is displayed.
RTK Signal Format
Press the key to display the RTK signal format.
This format must be output from the base station to receive corrections on the Phoenix 300 receiver.
Press the key and use the or arrow keys to modify the RTK signal format accepted by the
Phoenix 300 receiver.
To Next Page
Loading...
