CHAPTER
4
Manual No. 016-0171-548 Rev. C 27
C hapter 4
Configuration Menus
Correction Configuration Menu
Access the Correction Configuration menu to set the differential correction source used with the Phoenix 300
receiver.
Press the key until the Correction Configuration screen is displayed.
Note: If ‘None’ is selected, the Phoenix 300 will not receive a differential correction signal. In this mode,
the position reported by the receiver is only accurate to within 30 feet [9 m] of the actual vehicle
position.
Phoenix 300 receivers with GPS engine firmware OEM 6.400 or newer are not compatible with
OmniSTAR correction services. See the Receiver Display Menu section on page 13 section for
assistance with verifying the firmware version installed on the receiver. Contact a local Raven
dealer for information on correction services available for Phoenix 300 receivers with newer
firmware versions or for additional assistance.
To Next Page
Loading...
