RCm KILO - Squeegee Rubber Selection Guide

25
Selection of type of squeegee rubbers
Selection of the most appropriate rubbers is essential for cleaning surfaces.
You can perform the activity more quickly with the proper rubbers; furthermore, the cost savings from this increase
in productivity can be substantial.
NOTE!
The table below shows a selection of the most used products. For special requirements, contact the RCM rep-
resentative.
SELECTION TABLE OF TYPE OF RUBBERS FOR SQUEEGEE
Type of  oor/Colour of
rubbers
(Polyure-
thane)
SH35
(Linatex)
SH35
(Natural
rubber)
SH33
(Natural
rubber)
SH37
(Natural
rubber)
SH40
Floor with fatty oil, acids. √
Quartz concrete  oor, rough
 oor and  oor without joints
(without joints between the
tiles).
√
Floor with joints (with joints be-
tween the tiles); very thorough
drying of the  oor.
√
Floor with joints (with joints be-
tween the tiles); average drying
of the  oor.
√
Floor with joints (with joints be-
tween the tiles); light drying of
the  oor.
√
Installation/removal of squeegee rubbers
See the procedure in the Maintenance chapter for installation/removal of the squeegee's rubbers.