39
Cleaning the suction lter
1. Remove the vacuum motor (see procedure in the speci c paragraph).
2. Remove the suction lter (A) from the support (B).
3. Clean the suction lter with a brush and compressed air (max. 5 Bar). Replace the lter if worn.
!
ATTENTION!
Appropriately protect body parts (eyes, hair, hands, etc.) when cleaning with compressed air or water guns.
4. Assemble, following the disassembly operations in reverse.
Cleaning the detergent solution (or washing water) lter
1. With the machine's controls, lower the squeegee and the disc brush, then turn the ignition key to “0” and ex-
tract it (see Use chapter).
2. Operate on the right side of the machine to unscrew and remove the transparent cover with lter (D).
3. Remove the lter (E) from the transparent cover (F).
4. Clean the lter (E) and the transparent cover (F).
5. Replace the lter (E) in its transparent cover case (F).
6. Screw the transparent cover with lter (D) in its seat.
7. Rotate the ignition key to “I” and wait for the squeegee and the disc brush to lift, then rotate the ignition key to
“0” and extract it.
A
B
D
E
F
D
To Next Page
Loading...
