6
INTRODUCTION
Purpose and contents of the manual
This Manual has the purpose of providing the operator with all necessary information to be able to use the machine in
the most suitable, independent and safest way possible. It includes information on safety, technical aspect, operation,
machine stop, maintenance, spare parts and scrapping.
Before performing any operation on the machine, the operators and quali ed technicians must carefully read the
instructions in this manual. If in doubt on correct interpretation of the instructions, contact the Manufacturer RCM for
any explanations.
Recipients
This manual is for both the operator and quali ed maintenance technicians of the machine.
The operators must not perform operations reserved for quali ed technicians. RCM is not liable for damages resulting
from failure to observe this prohibition.
Storage of the manual
This manual must be stored next to the machine, in the special bag, protected from liquids and anything else that may
jeopardise readability.
Declaration of conformity
The declaration of conformity supplied with the machine certi es compliance of the machine with the provisions of
law in force.
NOTE:
The original CE declaration of conformity is in the documentation attached to the machine.
Identi cation data
The serial number and model of the machine are shown on the label (A) a xed to the frame and can be read after
having extracted the batteries case (B) (See Maintenance chapter to open the batteries case).
The machine's year of manufacture is shown on the declaration of conformity; it is also indicated by the rst four digits
of the machine's serial number.
This information is necessary when ordering spare parts for the machine. Use the following space to note the ma-
chine's identi cation data.
MACHINE model | MACHINE serial number
A
B
To Next Page
Loading...
