RCm KILO - Maintenance Procedures: Squeegee; Cleaning the Squeegee

35
Check of machine operating hours
1. Sit on the machine seat.
2. Rotate the ignition key to “I”, then wait a few seconds until the caption (B) “READY” appears on the display (A).
3. Zone (C) displays the number of machine operating hours.
4. Rotate the machine's ignition key to “0” and extract it.
Cleaning the squeegee
NOTE!
The squeegee must be clean and the rubbers in good condition for the  oor to be well-dried.
!
WARNING!
It is advisable to use protective gloves when cleaning the squeegee since there can be sharp debris.
1. Disassemble the squeegee, if necessary (See procedure in the speci c paragraph).
2. Wash and clean the squeegee (D); clean the compartments (E) and the recovery water passage hole (F) from
dirt and debris.
Check that the front rubber (G) and the rear rubber (H) are intact and have no cuts or tears, otherwise replace
them (see the procedure in the speci c paragraph).
3. Reassemble the squeegee if disassembled (See procedure in the speci c paragraph).
E
B
A
C
D
E
E
F
G
H