RCm KILO - Squeegee Height Adjustment; Maintenance Procedures: Brushes and Tanks; Cleaning the Disc Brush

37
Squeegee height adjustment
Adjustment of the squeegee height is necessary when the machine does not dry properly, leaving trails of water in
the central or external areas.
• To adjust the height, loosen the locknut (A) and adjust the height of the wheel (B) with the hex wrench (C);
tighten the locknut (A) when adjusted.
Repeat the operation on the wheel on the other side of the machine.
Cleaning the disc brush
!
WARNING!
It is advisable to use protective gloves when cleaning the disc brush because there can be
cutting debris.
1. Disassemble the disc brush if necessary (See procedure in the speci c paragraph).
2. Wash and clean the disc brush (D) from dirt and debris.
3. Reassemble the disc brush if disassembled (See procedure in the speci c paragraph).
4. The disc brush must be replaced for excessive wear when, with the brush lowered, the side pins (E) rest on the
lower ends (F) of the slots.
E
F
D
A
C
B