Core Server Configuration Attributes Reference
48 Red Hat Directory Server Configuration, Command, and File Reference • May 2005
nsslapd-auditlog-logexpirationtimeunit (Audit Log Expiration Time Unit)
Specifies the units for the
nsslapd-auditlog-logexpirationtime
attribute. If
the unit is unknown by the server, then the log will never expire.
nsslapd-auditlog-logging-enabled (Audit Log Enable Logging)
Turns audit logging on and off.
For audit logging to be enabled, this attribute must have a valid path and
filename and the
nsslapd-auditlog-logging-enabled
configuration attribute
must be switched to
on
. The table below lists the four possible combinations of
values for these two configuration attributes and their outcome in terms of
disabling or enabling of audit logging.
Entry DN: cn=config
Valid Values: month | week | day
Default Value: week
Syntax: DirectoryString
Example: nsslapd-auditlog-logexpirationtimeunit: day
Entry DN: cn=config
Valid Values: on | off
Default Value: off
Syntax: DirectoryString
Example: nsslapd-auditlog-logging-enabled: off
Attributes in dse.ldif Value Logging enabled or disabled
nsslapd-auditlog-logging-enabled
nsslapd-auditlog
on
empty string
Disabled
nsslapd-auditlog-logging-enabled
nsslapd-auditlog
on
filename
Enabled
To Next Page
Loading...