EasyManuals Logo

Renesas R8C series User Manual

Renesas R8C series
341 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #156 background imageLoading...
Page #156 background image
R8C/1A Group, R8C/1B Group 14. Timers
Rev.1.30 Dec 08, 2006 Page 138 of 315
REJ09B0252-0130
Figure 14.21 Registers TZMR and PUM in Programmable Wait One-Shot Generation Mode
Timer Z Waveform Output Control Register
Symbol Address After Reset
PUM
0084h 00h
Bit Symbol Bit Name Function RW
INT0
_
____
pin one-shot trigger 0 : INT0
_
____
pin one-shot trigger disabled
control bit
(1)
1 : INT0
_
____
pin one-shot trigger enabled
INT0
_
____
pin one-shot trigger
polarity select bit
(2)
NOTES :
1.
2.
Set the INOSTG bit to 1 after the INT0EN bit in the INTEN register and the INOSEG bit in the PUM
register are set. When setting the INOSTG bit to 1 (INT0
_
____
pin one-shot trigger enabled), set the INT0F0 to
INT0F1 bits in the INT0F register. Set the INOSTG bit to 0 (INT0
_
____
pin one-shot trigger disabled) after the
TZS bit in the TZMR register is set to 0 (count stops).
The INOSEG bit is enabled only w hen the INT0PL bit in the INTEN register is set to 0 (one edge).
RW
INOSEG RW
RW
TZOPL RW
0 : Falling edge trigger
1 : Rising edge trigger
Reserved bits Set to 0.
Timer Z output level latch 0 : Outputs one-shot pulse “H.
OutputsL” w hen the timer is stopped.
1 : Outputs one-shot pulse “L”.
OutputsHw hen the timer is stopped.
b7 b6 b5 b4
00
b3 b2
INOSTG
b1 b0
0
(b4-b0)
00
Timer Z Mode Register
Symbol Address After Reset
TZMR
0080h 00h
Bit Symbol Bit Name Function RW
NOTES :
1.
2. Refer to
14.2.5 Notes on Timer Z
for precautions regarding the TZS bit.
b0
When the TZS bit is set to 1 (count starts), the count value is w ritten to the reload register only. When the TZS bit is
set to 0 (count stops), the count value is w ritten to both reload register and counter.
TZWC
TZS
Timer Z w rite control bit Set to 1 in programmable w ait one-shot generation
mode.
(1)
0
b3 b2 b1
0
TZMOD1
b7 b6 b5 b4
111
Timer Z count start flag
(2)
0 : Stops counting.
1 : Starts counting.
0
(b3-b0)
Reserved bits
RW
RW
0
Set to 0.
RW
Timer Z operating mode
bits
b5 b4
1 1 : Programmable w ait one-shot generation mode
RW
TZMOD0 RW

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Renesas R8C series and is the answer not in the manual?

Renesas R8C series Specifications

General IconGeneral
BrandRenesas
ModelR8C series
CategoryComputer Hardware
LanguageEnglish

Related product manuals