Revolectrix Dual PowerLab 8x2 User Manual

79
Safety Code #119
Bananas connected while charging
Safety Code #120
Cell count not verified
Safety Code #121
Shunt FET off while CHG/DSCHING
Safety Code #122
Unknown chemistry
Safety Code #123
No next charge screen to show
Safety Code #124
Bad run screen number
Safety Code #125
Cell count is zero
Safety Code #126
Serial0 recursive overflow
Safety Code #127
Discharge mode timeout
Safety Code #128
Peek detect set past 15 minutes
Safety Code #129
NiCd/NiMH chem. must use fallback
Safety Code #130
Lith chem. Must not use fallback
Safety Code #131
Oscillator calibration erased. Send back to factory
Safety Code #132
Bad amps calibration. Send back to factory
Safety Code #133
PWM duty cycle too low
Safety Code #134
Bad options on expansion channel
Safety Code #135
Zero amps PWM too high
Safety Code #136
Charge and discharge are enabled
Safety Code #137
Bad preset checksum in ram
Safety Code #138
Discharge amps are positive
Safety Code #139
Discharge is over 120 watts
Safety Code #140
Amps set too low
Safety Code #141
Cell detection minutes is zero
Safety Code #142
No prev charge screens to show
Safety Code #143
Corrupt charge voltage
Safety Code #144
Copy preset error
Safety Code #145
Discharge set amps out of range
Safety Code #146
Discharge cutoff volts error
Safety Code #147
Discharge and bypass are enabled
Safety Code #149
Bypass and discharge at the same time
Safety Code #151
PWMOUT16 is zero
Safety Code #152
Switching frequency changed while charging
Safety Code #154
Bad Exp. Ch. Preset CRC
Safety Code #155
Exp. Ch. Start error
Safety Code #156
Network buffer full
Safety Code #157
Unknown NETBUFFER command
Safety Code #159
Discharge over current
Safety Code #200
Memory dump location 1

Revolectrix Dual PowerLab 8x2 Specifications

General

Brand	Revolectrix
Model	Dual PowerLab 8x2
Category	Battery Charger
Language	English