● Female connector strip (already mounted)
1)
● Antistatic bag
1)
● Lithium battery (already inserted)
2)
3 Use of the safety instructions
3.1 Structure of the safety instructions
The safety instructions are structured as follows:
Burns and chemical burns due to wrong
battery treatment!
CAUTION
Safety alert symbol
Signal word
Consequences and
source of danger
Avoiding danger
Do not open the batteries and do not heat them over 80 °C.
Fig. 3-1: Structure of the safety instructions
3.2 Explaining signal words and safety alert symbol
The safety instructions in this documentation contain specific signal words (dan-
ger, warning, caution, notice) and, if necessary, a safety alert symbol (according
to ANSI Z535.6-2006).
The signal word is used to draw attention to the safety instruction and also pro-
vides information on the severity of the hazard.
The safety alert symbol (a triangle with an exclamation point), which precedes
the signal words danger,warning and caution is used to alert the reader to per-
sonal injury hazards.
In the event of non-compliance with this safety instruction, death or serious in-
jury will occur.
1)
Not included in the scope of delivery of the controls with parts numbers R911170827 and
R911170899.
2)
Only included in the scope of delivery of control L85 and the controls with part numbers
R911170827 and R911170899.
Bosch Rexroth AG
Use of the safety instructions
L25, L45, L65, L75 and L85
4/53
DOK-CONTRL-IC*LX5*****-IT02-EN-P
To Next Page
Loading...
Need help?
General
