8 Standards
8.1 Standards used
Standard Meaning
DIN EN 60 204-1 Safety of machinery - Electrical equipment of machines
DIN EN 61 131-2 Programmable logic controllers
Equipment and test requirements
DIN EN 60 529 Degrees of protection (including housings and installation com-
partments)
UL 508 Industrial Control Equipment
Tab. 8-1: Standards used
8.2 CE marking
8.2.1 Declaration of conformity
The electronic products described in the present operating instructions comply
with the requirements and the target of the following EU directive and with the
following harmonized European standards:
EMC directive 2004/108/EC
The electronic products described in the present operating instructions are in-
tended for use in industrial environments and comply with the following require-
ments:
Standard
Title Edition
DIN EN 61000-6-4
(VDE 0839-6-4)
Electromagnetic compatibility (EMC)
Part 6-4: Generic standards – Emission standard for indus-
trial environments (IEC 61000-6-4:2006)
September 2007
DIN EN 61000-6-2
(VDE 0839-6-2)
Electromagnetic compatibility (EMC)
Part 6-2: Generic standards – Noise immunity for industrial
environments (IEC 61000-6-2:2005)
March 2006
Tab. 8-2: Standards for electromagnetic compatibility (EMC)
Loss of CE conformity due to modifications at the device.
CE marking applies only to the device upon delivery. After modifying
the device, verify CE conformity.
Bosch Rexroth AG
Standards
L25, L45, L65, L75 and L85
12/53
DOK-CONTRL-IC*LX5*****-IT02-EN-P
To Next Page
Loading...
Need help?
General
