REXROTH IndraControl L25 User Manual

1 About this documentation
Overview on target groups and product phases
In the following illustration, the framed activities, product phases and target
groups refer to the present documentation.
Example: In the product phase "Mounting (assembly/installation)", the target
group "mechanic/electrician" can execute the activity "install" using this docu-
mentation.
Presales Aftersales
Selection
Mounting
(assembly/installation)
Engineering Commissioning Operation Decommissioning
Product
phases
Target
groups
Activities
Design engineer
Programmer
Technologist
Process
specialist
Select
Prepare
Design
Construct
Mechanic/
electrician
Unpack
Mount
Install
Programmer
Commissioning engineer
Parameterize
Program
Configure
Simulate
Technologist
Process specialist
Optimize
Test
Machine
operator
Maintenance
technician
Service
Operate
Maintain
Remove
faults
Create
the NC program
Mechanic/
electrician
Disposal company
Dismount
Dispose
Fig. 1-1: Assigning the present documentation to the target groups, product phases and ac-
tivities of the target group
This document instructs the technical staff of the machine manufacturer on how
to safely perform the mechanic and electrical installation and on how to com-
mission the device.
Required qualifications: Individual who is able to assess the tasks assigned and
to identify possible safety risks owing to qualification in the subject, knowledge
and experience. The individual should also be familiar with the standards and
regulations.
Scope
This operating instructions is valid for all variants of the control, whose type co-
des start with:
CML25.1...
CML45.1...
L25, L45, L65, L75 and L85
Bosch Rexroth AG
About this documentation
DOK-CONTRL-IC*LX5*****-IT02-EN-P
1/53

REXROTH IndraControl L25 Specifications

General

Brand	REXROTH
Model	IndraControl L25
Category	Control Unit
Language	English