RE 30126-01-B/08.07 | Manual Hydraulics | Bosch Rexroth AG 24/76
Application: Valve control for the 4WRE6 / 4WRE10 3
In the motion data screen inputs DI1 to DI5 are only updated if DI6
shows a High level.
The active block can be calculated according to the following:
Active block = 8*DI4 + 4*DI3 + 2*DI2 + 1*DI1
where DIx = 0 if input shows a Low level (0V)
DIx = 1 if input shows a High level (24V).
The following shows the relationships of the digital inputs in a truth table.
Active Block DI4
Binary 8
DI3
Binary4
DI2
Binary 2
DI1
Binary 1
0 0 0 0 0
1 0 0 0 1
2 0 0 1 0
3 0 0 1 1
4 0 1 0 0
5 0 1 0 1
6 0 1 1 0
7 0 1 1 1
… … … … …
12 1 1 0 0
13 1 1 0 1
14 1 1 1 0
15 1 1 1 1
The blocks are activated by the high end controller (SPS / PLC) according to the table
shown using the digital inputs.
An overview of the connected signals to the controller and active block
can be found in the „Motion data“ window described in the Section
“Testing the application settings„.
To Next Page
Loading...
