RE 30126-01-B/08.07 | Manual Hydraulics | Bosch Rexroth AG 73/76
BODAC – Menu Description 5
Faults
In this window you specify which error messages for the control circuit you want to
output and log.
Clicking on the preceding icon, which is a component of the toolbar,
also opens the “Faults” window. A list of existing shortcuts for the
toolbar can be found in Section 4.2 “BODAC Toolbar”.
See also: Section 3.4 “Configure profiles”.
Test jacks
In the “Test jacks” window the signals can be assigned that are available for
diagnostic purposes on test jack “X1” and “X2” on the front panel of the controller
card.
Clicking on the preceding icon, which is a component of the toolbar,
also opens the “Test points” window. A list of existing shortcuts for the
toolbar can be found in Section 4.2 “BODAC Toolbar”.
See also: Section “Check Process Settings”
To Next Page
Loading...
