REXROTH VT-VRPD-2 - Page 39

RE 30126-01-B/08.07 | Manual Hydraulics | Bosch Rexroth AG 39/76
User interface BODAC - General 4
F3
Sends the settings and entries you made to the card and overwrites
the previously saved data in volatile memory. (see also “Write
Parameters”)
F11
If you are in an entry f
ield, you can press “F11” to increment the field
contents. Simultaneously BODAC writes this parameter to the card.
F12
If you are in an entry field, you can press “F12” to decrement the field
contents. Simultaneously BODAC writes this parameter to the card.
Page-
down
If you are in the structure editor in the entry field block, you can use
“Page down” to increment the field contents. This then opens the next
higher block.
Page-
up
If you are in the structure editor in the entry field block, you can use
“Page up” to decrement the field contents. This then opens the next
lower block.